Above-ground Installation
Above-ground Installation
This picture timeline shows the installation process for an 18' by 34' oval Doughboy aboveground pool with a flat bottom and E-Z Clip liner. Exact installation methods will vary for other pool shapes, sizes, models, and features. A special thank you to our customer, Greg Nix, for compiling the photos for Brown's Pools & Spas.
The installation process begins by measuring and marking the area where the pool will be installed.
Measured and Marking
First, all of the turf must be scraped off and removed.
Turf Removed
Turf Removed
The pool pad elevation is checked and double-checked with a transit level before the pool assembly can begin.
Pool Pad Elevation
Our installers are experts at Bobcat loader operation.
Bobcat Process
While the excavation is underway, unpacking of the pool kit begins.
Pool Kit
The exact location of the pool walls are remarked.
Pool Walls Are Remarked
Installation of the side wall supports begins with the burying of foundation blocks.
Installation Of The Side Wall Supports
Installation Of The Side Wall Supports
Radius End Wall Rail Installed
The radius end wall bottom rail is installed.
Radius End Wall Rail Installed
Pressure Plates Installed
Support System Installation Is Complete.
Support Systems
Fine masonry sand is spread for the pool floor.
Pool Floor
Pool Floor
Pool Floor
Corrugated Metal Wall & Vertical Support
The crew installs bead receiver and stabilizer rails as the wall is unrolled.
Bead Receiver & Stabilizer Rails
With sand in place, setup of the corrugated metal wall and vertical support is underway.
Corrugated Metal Wall & Vertical Support
Bead Receiver & Stabilizer Rails
Wall Seam Joiner Installed
Bead Receiver & Stabilizer Rails
The wall seam joiner is installed to complete the wall setup.
Wall Seam Joiner Installed
Sand is banked slightly to the pool wall to form a cove to support the liner.
Support The Liner
Before the liner installation, the sand floor is re-smoothed and packed.
Sand Floor Smoothed & Packed
The liner is unpacked and spread across the pool.
Liner Is Unpacked
An E-Z Clip liner mounts in the receiver and filling of the pool begins.
E-Z Clip Liner
Next, the top rails of the pool structure are installed.
Top Rails Installed
Skimmer & Return Assemblies
Precise cuts must be made in the new pool liner to install the skimmer and return assemblies.
Skimmer & Return Assemblies
Plumbing Lines
Final connections are made and the new filter system is ready to operate.
Filter System Ready To Operate
Plumbing lines are run from the skimmer to the equipment pad- most pools have one skimmer and return.
Plumbing Lines
Add a great looking deck, some new patio furniture, and the backyard vacation is ready for a summer of fun.
Add a Deck
Aboveground Installation Process Completed
Thank you again to the Nix Family, we hope you enjoy your pool for many years to come.